Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·857·
Variables related to the programmed functions.
(V.)[ch].G.ORGROT
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Rotation angle of the coordinate system.
Syntax.
·ch· Channel number.
BLOCK REPETITION.
(V.)[ch].G.PENDRPT
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of pending repetitions with #RPT.
Syntax.
·ch· Channel number.
Remarks.
This variable indicates the number of repetitions left to execute. In the first execution, its value
is the programmed number of repetitions minus one and in the last one, its value is zero.
(V.)[ch].G.PENDNR
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of pending repetitions with NR.
Syntax.
·ch· Channel number.
Remarks.
This variable indicates the number of repetitions left to execute. In the first execution, its value
is the programmed number of repetitions minus one and in the last one, its value is zero.
AXIS SLAVING.
(V.)[ch].G.LINKACTIVE
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Axis slaving (coupling) status.
Syntax.
·ch· Channel number.
V.[2].G.ORGROT Channel ·2·.
V.[2].G.PENDRPT Channel ·2·.
V.[2].G.PENDNR Channel ·2·.
V.[2].G.LINKACTIVE Channel ·2·.
To Next Page
Loading...
