Fagor CNC 8060 - Page 884

·884·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
General variables of the CNC.
DATE, TIME AND AMOUNT OF TIME OF TURNED ON.
(V.)G.DATE
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Date in year-month-day format.
Values of the variable.
If the date is "April 25th 1999", the returned value will be 990425.
Remarks.
This variable updates its value every hour.
(V.)G.TIME
Variable that can only be read from the program, PLC (asynchronous) and interface.
The variable returns the execution value; reading it interrupts block preparation.
Time in hours-minutes-seconds format.
Values of the variable.
If the time is "18hr 22min 34s", the returned value will be 182234.
(V.)G.CLOCK
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Seconds since the CNC was turned on.
INFORMATION ABOUT THE CHANNELS.
(V.)[ch].G.CNCHANNEL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel number.
Syntax.
·ch· Channel number.
(V.)G.FOCUSCHANNEL
Variable that can be read and written from the PLC and from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Channel with active focus.
V.G.DATE
V.G.TIME
V.G.TIME
V.[2].G.CNCHANNEL Channel ·2·.
V.G.FOCUSCHANNEL