Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·885·
General variables of the CNC.
KEY SIMULATION.
(V.)G.KEY
Variable that can be read and written from the PLC and read from the program and from the interface.
The variable returns the execution value; reading it interrupts block preparation.
Code of the last key accepted by the CNC.
Remarks.
To read the last key that has been accepted by the CNC or simulate the keyboard from the
PLC by writing in it the code of the desired key.
V.G.KEY
To Next Page
Loading...
