Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·893·
Variables associated with the part-program being executed.
1 The variable is initialized when selecting and executing the program.
2 When executing the #EXEC instruction, the variable is re-initialized because the program
in execution has changed.
3 If then, this program is executed again, the program in execution changes again and the
variable is updated.
In this case, to keep track of how many times the program has been executed, it is
recommended to use an arithmetic parameter at the end of the program like a counter.
(V.)[ch].G.CYTIME
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Part-program execution time (in hundredths of a second).
Syntax.
·ch· Channel number.
Remarks.
This variable is set to 0 at every new execution even of the same program. It does not measure
the time that execution has been stopped.
EXECUTING OPTIONS; SINGLE BLOCK, RAPID, ETC..
(V.)[ch].G.SBOUT
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
"Single block" function activated.
Syntax.
·ch· Channel number.
Remarks.
The single block function may be activated or canceled from the keyboard or from the PLC
(SBLOCK mark). To activate it, just set one of them high (=1), but to cancel it both must be
low (=0).
(V.)[ch].G.SBLOCK
Variable that can be read and written from the interface and read from the program and from the PLC.
The variable returns the execution value; reading it interrupts block preparation.
"Single block" function requested via keyboard.
Syntax.
·ch· Channel number.
V.[2].G.CYTIME Channel ·2·.
V.[2].G.SBOUT Channel ·2·.
V.[2].G.SBLOCK Channel ·2·.
To Next Page
Loading...
