Fagor CNC 8060 - Page 93

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·93·
General machine parameters. Execution channels.
TABLETOP PROBE POSITION.
PROBEDATA
Channel related probe parameters.
PRB1MAX
Maximum probe coordinate (first axis of the channel).
Possible values: Within ±99999.9999 mm / within ±3937.00787 inch.
Default value: 0.
Associated variable: (V.)[ch].MPG.PRB1MAX
See general machine parameter PRB3MIN.
PRB1MIN
Minimum probe coordinate (first axis of the channel).
Possible values: Within ±99999.9999 mm / within ±3937.00787 inch.
Default value: 0.
Associated variable: (V.)[ch].MPG.PRB1MIN
See general machine parameter PRB3MIN.
PRB2MAX
Maximum probe coordinate (second axis of the channel).
Possible values: Within ±99999.9999 mm / within ±3937.00787 inch.
Default value: 0.
Associated variable: (V.)[ch].MPG.PRB2MAX
See general machine parameter PRB3MIN.
PRB2MIN
Minimum probe coordinate (second axis of the channel).
Possible values: Within ±99999.9999 mm / within ±3937.00787 inch.
Default value: 0.
Associated variable: (V.)[ch].MPG.PRB2MIN
See general machine parameter PRB3MIN.
PRB3MAX
Maximum probe coordinate (third axis of the channel).
Possible values: Within ±99999.9999 mm / within ±3937.00787 inch.
Default value: 0.
Associated variable: (V.)[ch].MPG.PRB3MAX
See general machine parameter PRB3MIN.
This parameter shows the table to define the position of the
tabletop probe on the first three axes of the channel
according to parameter CHAXISNAME. The table shows
the following parameters to configure it.
PROBEDATA
PRB1MAX Maximum probe coordinate (first axis of the channel).
PRB1MIN Minimum probe coordinate (first axis of the channel).
PRB2MAX Maximum probe coordinate (second axis of the channel).
PRB2MIN Minimum probe coordinate (second axis of the channel).
PRB3MAX Maximum probe coordinate (third axis of the channel).
PRB3MIN Minimum probe coordinate (third axis of the channel).