·94·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
General machine parameters. Execution channels.
PRB3MIN
Minimum probe coordinate (third axis of the channel).
Possible values: Within ±99999.9999 mm / within ±3937.00787 inch.
Default value: 0.
Associated variable: (V.)[ch].MPG.PRB3MIN
These parameters define the position of the tabletop probe used for tool calibration. They
must be defined in absolute coordinates referred to machine reference zero.
For a LATHE model CNC, the coordinates must be given in radius.
BLOCK SEARCH.
FUNPLC
Send the M, H, S functions to the PLC during block search..
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPG.FUNPLC
With block search, it is possible to recover the program history up to a particular block, that
may be in a program or in a subroutine, in such way that if program execution is resumed
at that block, it will do so with the same conditions as if it were executed from the beginning.
This parameter determines whether or not the CNC sends the M, H, S functions to the PLC
during block search. The M function table has an MPLC field to define whether the CNC
sends the function to the PLC or not. All M functions set in the table will be sent out to the
PLC or not depending on this field regardless of the setting of machine parameter FUNPLC.
INTERRUPTION SUBROUTINES.
SUBINTSTOP
Execute interruption subroutines while the program is stopped or
while no program is in execution.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPG.SUBINTSTOP
This parameter determines whether the CNC must execute the interruption subroutine when
the program is interrupted (STOP) or no program is in execution (channel in READY state).
In order to execute the subroutine when no program is in execution, the channel must be
in automatic mode; the subroutine cannot be executed from jog mode.
FUNPLC Meaning.
Yes In this case, the functions are sent out to the PLC during block search as they
are being read. Once block search ends and after repositioning the axes, the
CNC shows the "MHSF" softkey for executing any function of this type, thus
modifying the machining conditions.
No In this case, the functions are not sent out to the PLC during block search. After
the search, the CNC screen shows the history of those functions so the user can
enable them in the desired order.
X
Y
PRB1MAXPRB1MIN
PRB2MAX
PRB2MIN
Z
X
Y
X
Z
PRB1MAXPRB1MIN
PRB3MAX
PRB3MIN
To Next Page
Loading...
