DTC4500e_User Guide_EN, PLT-01669, Rev. 1.1
4.7.3.4 Write Only
Click to use rewritable cards. The default setup is for the printer to first erase the entire card and
then write new information on the card. There is no option to select specific areas to erase.
However, to print or erase a section, use the Overlay/Print Area tab. Select the specific area in the
same manner as a print job with a color ribbon.
To erase many cards, use the FARGO Workbench Re-Writable Card Eraser option. It does not print.
It only erases.
Note: No ribbon is used with rewritable cards. Do not load a ribbon into the printer when using this
process. Printing on a rewritable card with a ribbon will ruin the card.
4.7.3.5 Encrypt Job Data
Click this option to encrypt information about the print job for enhanced security.
To Next Page
Loading...
