EasyManuals Logo

Fargo DTC4500e User Manual

Fargo DTC4500e
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
DTC4500e_User Guide_EN, PLT-01669, Rev. 1.1
Page 8 April 2014
1.1.2 United States
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference; in which case, you are required to correct the interference at your expense.
IMPORTANT: Changes or modifications to an intentional or unintentional radiator not expressly
approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
1.1.3 Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
1.1.4 Taiwan
經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變
更頻率、加大功率或變更原設計之特性及功能。低功率射頻機之使用不得影響飛
航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無干擾時方
得繼續使用。前項合法通信,指依電信法規定作業之無線電通信。低功率射頻電機
須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
1.1.5 Japan
この装置は総務省の型式指定を受けています。"
(総務省指定番号はAC-14019号です)
本製品は電波を使用しRFID 機器の読み取り・書き込み装置です。
そのため使用する用途・場所によっては、医療機器に影響を与える恐れがあります

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fargo DTC4500e and is the answer not in the manual?

Fargo DTC4500e Specifications

General IconGeneral
Print TechnologyDye-Sublimation / Resin Thermal Transfer
Resolution300 dpi
Supported Card SizesCR-80, CR-79 adhesive back
Memory32 MB RAM
Operating System SupportedWindows 7, 8, 10, Server 2008, 2012, 2016
Print SpeedUp to 225 cards per hour (YMCKO)
Card Capacity100 cards
ConnectivityUSB 2.0, Ethernet
Print CapabilitySingle-sided or dual-sided printing
Power Requirements100-240V AC, 50/60Hz
Operating Humidity20-80% RH
Card Thickness9 mil to 40 mil
Operating Temperature65° F to 90° F / 18° C to 32° C

Related product manuals