Fargo DTC4500e - Additional Printer Specific Tools

DTC4500e_User Guide_EN, PLT-01669, Rev. 1.1
April 2014 Page 87
6.1.4.1 Additional Printer Specific Tools
Label Description
INFO
Printer Type
Firmware Version
IP Address
Flipper
Lamination
Magnetics
E-Card
Password
Card count
TEST PRINTS Color Photo: Select this choice to print a color card to test
communication and integrity.
Alignment: Select this choice to print a card used to align the print
image on the card.
Settings: Select this choice to print a card with the Advanced settings.
Resin: Select this choice to print a RESIN test card.
Rewritable: Select this choice to ERASE the Rewritable card.
Magnetic: Select this choice to test Magnetic encoding. (Hi-Co only)
Lamination: Select this choice to laminate a test card.
Hopper Select
Select the hopper to input cards. Applies to dual-hopper printers.
Toolbox Clean Printer: Select this choice to run the clean printer routine.
Clean Laminator: Select this choice to run the clean laminator routine.
Calibrate Mag: Select this choice to calibrate the Magnetic Sensor.
Calibrate Rib Sensor: Select this choice to calibrate the ribbon sensor.
Network: Select this to choice configure network options
Language Language: Select this choice to change the Printer Displayed
Language.
Exit Exit: Select this choice to exit the Printer Tool options.