DTC4500e_User Guide_EN, PLT-01669, Rev. 1.1
Error Message Cause Solution
# 82 Mag Jam
A card is jammed magnetic
station
Clear any cards in the magnetic
station using the buttons to move
the card out.
Press the Pause button to
continue.
# 91
Ribbon Out
The print ribbon has run out. Install a new ribbon.
Press the Pause button to
continue or the ON/OFF button to
cancel.
# 93
Wrong Ribbon
The print ribbon installed in the
printer does not match the
ribbon type selected in the
printer driver.
Change either the installed print
ribbon or the ribbon type selected
in the printer driver.
Press the Pause button to
continue or the ON/OFF button to
cancel.
# 97
Ribbon Search Error
The ribbon is not able to find the
next panel correctly.
Check for jams/breaks.
Recalibrate the ribbon sensor.
If broken, repair by taping the
ribbon back on to the take- up
core.
Replace the ribbon.
Press the Pause button to
continue or the ON/OFF button to
cancel.
# 99
Ribbon Error
The print ribbon has either
broken or jammed.
If jammed, clear the jam.
If broken, repair by taping the
ribbon back on to the take- up
core.
Press the Pause button to
continue or the ON/OFF button to
cancel.
# 100
Ribbon RFID Error
There is no ribbon or the ribbon
tag information is corrupted or
incorrect.
Verify the printer driver settings
for correct Ribbon.
Try a new ribbon and continue.
Press the ON/OFF button to
cancel.
To Next Page
Loading...
