Farr HD8625 - User Manual

Questions and Answers

D
Doris CalderonAug 5, 2025
What to do if Farr Power Tool torque gauge is indicating incorrectly?
- K
  Kevin ParrishAug 5, 2025
  If the torque gauge on your Farr Power Tool is indicating incorrectly, the issue might stem from several causes: * The incorrect gauge may be in use. Ensure the gauge is the proper range and has been properly calibrated for the arm length of the equipment in use. * The gauge may be damaged. Check its operation and calibration on an independent system. * The gauge may have mistakenly been paired with an incorrect load cell. In addition, consider that air trapped in the torque measuring circuit (load cell, hydraulic line, or gauge) could also cause incorrect readings.
T
tmillerAug 9, 2025
How to troubleshoot low torque in Farr Power Tool due to fluid viscosity?
- S
  Selena OwensAug 9, 2025
  If your Farr Power Tool isn't developing sufficient torque, the hydraulic fluid's viscosity might be the problem. Make sure the hydraulic fluid you're using matches what's recommended. If the fluid is too thick, the power unit pump might not prime correctly. If it's too thin, the hydraulic system could overheat. Replace the fluid with the correct viscosity. Also, environmental conditions can affect fluid viscosity, so ensure the fluid is suitable for the operating temperatures.
D
Dominic JacksonAug 14, 2025
What to do if Farr Power Tool jaws are slipping on pipe?
- C
  Christie FernandezAug 14, 2025
  If the jaws are slipping on the pipe when using the Farr Power Tool, check that the jaw dies aren't too worn to grip properly. Also, make sure you're using the correct size jaws for the pipe.
K
Kimberly TranAug 17, 2025
Why Farr Power Tool tong is not developing sufficient torque due to load cell issues?
- A
  Annette JacobsAug 18, 2025
  If your Farr Power Tool tong isn't developing sufficient torque, and you suspect the load cell is the issue, consider these possibilities: * The incorrect load cell may be in use. * The load cell may be damaged. If damaged, replace the load cell or return it for repair and re-calibration.
P
Paul DiazAug 22, 2025
What to do if Farr Power Tool gauge has been damaged?
- S
  Sarah EatonAug 22, 2025
  If the gauge on your Farr Power Tool has been damaged, check its operation and calibration on an independent system.
D
Donna BrownAug 27, 2025
What to do if Farr Power Tool load cell has been damaged?
- N
  Nicole GonzalezAug 27, 2025
  If the load cell in your Farr Power Tool has been damaged, replace it, or return it for repair and re-calibration.
E
Elizabeth RileyOct 31, 2025
Why Farr Power Tool tong will not develop sufficient torque?
- J
  Joseph HigginsOct 31, 2025
  Several factors can prevent the Farr Power Tool tong from developing sufficient torque. It could be due to: * A malfunctioning relief valve on the tong hydraulic circuit. * A leaking directional valve, which should return fluid directly to the reservoir in the neutral position. Replace or repair the valve to ensure correct operation. * The power unit not producing adequate pressure. Troubleshoot the power unit. * Poor hydraulic pressure at the tong despite adequate pressure at the power unit, or excessive back pressure in the return line, indicating restrictions in the line between the power unit and the tong. Inspect the integrity of self-sealing couplings and check for other restrictions like contaminated catch screens or filters. * Inappropriate fluid viscosity (too high or t...