MT100 Multipoint Flow Meter OPERATION
Service Data Operation
The Service Data functions are organized into 3 areas:
1. MT100 Series Basic Setup
2. MT100 Series Configuration
3. MT100 Series Factory Calibration Limits
Shown below is service information as seen through the Emerson 475 HART communicator with FCI’s DD files loaded. The same
information seen by the 475 is shown in the DCS (Distributed Control System) when the MT100 Series HART DD files are loaded.
MT100 Series Basic Setup
The Basic Setup function includes the ability to review and
change the engineering units of the process variables, review
and change the Plenum or pipe size, enable or disable the
Totalizer, review and change device information, reset the
operation of the MT100 to the factory settings, enable or
disable the write protect, and PV Setup.
Engineering Units Information
Fluid Components International LLC 45
To Next Page
Loading...
