OPERATION MT100 Multipoint Flow Meter
Factory Reset
WARNING – The factory Reset command re-loads the
configuration and calibration parameters that were loaded
into the instrument during the original cal and setup. Any
changes made to the configuration of calibration parameters
will be lost when the Factory Reset command is executed.
MT100 Series Configuration
The configuration function eases the setup of the individual 4-
20 mA current output channels.
MT100 Series Calibration Limits (Example)
The MT100 Series Calibration Limits function lets you review
the limits that have been set for the Flow and Temperature
process parameters.
Fluid Components International LLC 46
To Next Page
Loading...
