1 Safety and requirements for product use
10 Festo – GDCP-CMMP-M0-HW-EN – 1511c – English
1.1.2 Protection against electric shock through protective extra-low voltage (PELV)
Warning
Use for the electrical power supply only PELV circuits in accordance with EN 60204-1
(Protective Extra-Low Voltage, PELV).
Also take into account the general requirements for PELV circuits in accordance with
EN60204-1.
Use only power sources which guarantee reliable electrical isolation of the operating
voltage as per EN 60204-1.
Through the use of PELV circuits, protection from electric shock (protection from direct and indirect
contact) in accordance with EN 60204-1 is ensured (Electrical equipment of machines. General require
ments).
1.1.3 Intended use
The CMMP-AS-...-M0 is intended for ...
– Use in control cabinets for power supply to AC servo motors and their regulation of torques (cur
rent), rotational speed and position.
The CMMP-AS-...-M0 is intended for installation in machines or automated systems and may be used
only as follows:
– in excellent technical condition,
– in original status without unauthorised modifications,
– within the limits of the product defined by the technical data
(è Appendix A Technical appendix),
– in an industrial environment.
The product is intended for use in industrial areas. When used outside an industrial environment, e.g. in
commercial and mixed residential areas, measures for radio interference suppression may be ne
cessary.
Note
In the event of damage caused by unauthorised manipulation or other than intended
use, the guarantee is invalidated and the manufacturer is not liable for damages.
To Next Page
Loading...
Need help?
General
