1 Safety and requirements for product use
Festo – GDCP-CMMP-M0-HW-EN – 1511c – English 11
1.2 Requirements for product use
Make this documentation available to the design engineer, installer and personnel responsible for
commissioning the machine or system in which this product is used.
Make sure that the specifications of the documentation are always complied with. Also consider the
documentation for the other components and modules.
Take into consideration the legal regulations applicable for the destination, as well as:
– regulations and standards,
– regulations of the testing organizations and insurers,
– national specifications.
1.2.1 Transport and storage conditions
Protect the product during transport and storage from impermissible burdens, such as:
– mechanical loads,
– impermissible temperatures,
– moisture,
– aggressive atmospheres.
Store and transport the product in its original packaging. The original packaging offers sufficient
protection from typical stresses.
1.2.2 Technical requirements
General conditions for the correct and safe use of the product, which must be observed at all times:
Comply with the connection and environmental conditions of the product (è Appendix A) and all
connected components specified in the technical data.
Only compliance with the limit values or load limits will enable operation of the product in compli
ance with the relevant safety regulations.
Observe the instructions and warnings in this documentation.
1.2.3 Qualification of the specialists (requirements for the personnel)
The product may only be placed in operation by a qualified electrotechnician who is familiar with:
– the installation and operation of electrical control systems,
– the applicable regulations for operating safety-engineered systems,
– the applicable regulations for accident protection and occupational safety, and
– the documentation for the product.
1.2.4 Range of application and certifications
Standards and test values, which the product complies with and fulfils, can be found in the “Technical
data” section (è Appendix A). The product-relevant EU directives can be found in the declaration of
conformity.
Certificates and declaration of conformity on this product can be found at
è www.festo.com/sp.