4 Electrical installation
46 Festo – GDCP-CMMP-M0-HW-EN – 1511c – English
4.11 FCT interfaces
4.11.1 Overview of interfaces
1
2
1 [X19]: USB 2 [X18]: Ethernet
Fig. 4.7 FCT interfaces
4.11.2 USB [X19]
The equipment of the series CMMP-AS-...-M0 have a USB interface for parametrisation. The USB inter
face is used as a configuration interface for the FCT configuration.
The following functions are supported:
– Complete parametrisation of theCMMP-AS-...-M0 via FCT
– Firmware download via FCT
Interface design
The plug connector is designed as a Type B terminal socket. All standard terminal cables up to a length
of 5m can be used. If longer cables are required, the corresponding USB repeaters must be used.
The USB interface is designed as a pure slave interface (the CMMP-AS…-M0 is the slave, the PC is the
host). It meets the USB specification Rev. USB 1.1.
USB driver for the PC
The USB driver package is a component of the FCT installation.
The following operating systems are supported through this:
– Windows XP from Service Pack 2
– Windows Vista
– Windows 7
To Next Page
Loading...
Need help?
General
