1 Safety and requirements for product use
Festo – GDCP-CMMP-M0-HW-EN – 1511c – English 9
1 Safety and requirements for product use
1.1 Safety
1.1.1 Safety instructions for commissioning, repair and de-commissioning
Warning
Danger of electric shock.
– When cables are not mounted to the plugs [X6] and [X9].
– When connecting cables are disconnected when powered.
Touching live parts can result in severe injuries and even death.
The product may only be operated in a built-in status and when all protective measures
have been initiated.
Before touching live parts during maintenance, repair and cleaning work and when there
have been long service interruptions:
1. Switch off power to the electrical equipment via the mains switch and secure it
against being switched on again.
2. After switch-off, wait at least 5 minutes discharge time and check that power is
turned off before accessing the controller.
The safety functions do not protect against electric shock but only against dangerous
movements!
Note
Danger from unexpected movement of the motor or axis.
– Make sure that the movement does not endanger anyone.
– Perform a risk assessment in accordance with the EC machinery directive.
– Based on this risk assessment, design the safety system for the entire machine,
taking into account all integrated components. This also includes the electric drives.
– Bypassing safety equipment is impermissible.
To Next Page
Loading...
Need help?
General
