7 Maintenance, care, repair and replacement
64 Festo – GDCP-CMMP-M0-HW-EN – 1511c – English
7 Maintenance, care, repair and replacement
7.1 Maintenance and care
Warning
Danger of electric shock.
Touching live parts causes severe injuries and can lead to death. Do not disconnect
connecting cables when powered.
Before touching live parts during maintenance, repair and cleaning work and when there
have been long service interruptions:
1. Switch off power to the electrical equipment via the mains switch and secure it
against being switched on again.
2. After switch-off, wait at least 5 minutes discharge time and check that power is
turned off before accessing the controller.
If used as intended, the product is maintenance-free.
Clean the outside of the product with a soft cloth.
7.2 Repair
Repair or maintenance of the product is not permissible. If necessary, replace the com
plete product.
7.3 Replacement and disposal
7.3.1 Dismounting and installation
When dismounting, please observe the safety instructions in section 7.1
Information regarding installation can be found here:
– Mounting è Section 3.2.
– Electrical installation è Chapter 4.
– Commissioning è Chapter 5.
7.3.2 Disposal
Observe the local regulations for environmentally appropriate disposal of electronic mod
ules. The product is RoHS-compliant.
To Next Page
Loading...
Need help?
General
