2. Commissioning
2-17
Festo Festo P .BE CP FB13-E-EN en 9910c
Configuration with COM PROFIBUS 3.x
Prerequisites:
– Device data base exists in the directory of your pro-
grammer/PC
– Mask “Bus parameter” has been processed (bus profile,
baud rate)
– PROFIBUS address has been assigned (see above)
– Station type “FESTO CP FB13” has been selected (see
above)
Configuring Access the mask “Configure”:
1. Double click with the left-hand mouse key or with the
right-hand mouse key once on the symbol of the Festo
valve terminal.
2. Select “Configure” from the menu which appears.
The mask “Configure” appears (Fig. 2/8).
To Next Page
Loading...
