Festo CP Series User Manual

PLEASE NOTE
With end plates CPV..-EPL-PG (part no. 161 372
and 162 542) as well as with CPV..-EPR-PG (part
no. 161 373 and 162 543), connection 12/14 is sea-
led internally.
All available end plate combinations are listed in the
table below. Check that the end plates, which you wish
to fit, can in fact be combined (see end plate pairs lis-
ted below).
End plate pairs with internal auxiliary pilot air for
single tubing
Description
CPV..-EPL-G CPV..-EPR Connections only in left-hand
end plate. Division into
pressure zones not permitted.
Unused connections must be
sealed.
CPV..-EPL CPV..-EPR-G Connections only in right-
hand end plate. Division into
pressure zones not permitted.
CPV..-EPL-E CPV..-EPR-G Connections in left and right-
hand end plates.
Division into pressure zones
permitted.
5. Maintenance and conversion
5-14 CPV... 9802

Festo CP Series Specifications

General

Type	Controller
Series	CP
Category	Controller
Manufacturer	Festo
Operating Voltage	24 V DC
Protection Class	IP20
Communication Interface	CANopen, PROFINET
Programming Environment	Festo Automation Suite
Number of Axes	Varies (depending on model, typically up to 6 or more)