Fike FCP-75 - Compatible Products

Compatible Products Introduction
FCP-75 Manual — P/N LS10147-003FK-E:A 3/17/2021 11
1.3 Compatible Products
The chart below lists the products available for use with the FCP-75.
Output Point (or Output Circuit) A notification point or circuit for notification appliances. Relay circuits and auxiliary power circuits are also
considered output points.
Group (or “Output Group”) A group of output points. Operating characteristics are common to all output points in the group.
Output (or “Cadence”) Pattern The pattern that the output will use, for example, Constant, March Code, ANSI 3.41. Applies to zones
and special system events. See Appendix D for additional information.
Mapping Mapping is the process of specifying which outputs are activated when certain events occur in the
system. Figure 8.2 explains mapping in detail.
Network System Consist of any combination of 32 panels of these model numbers: FCP-75, FCP-300, FCP-300ECS,
FCP-2100 or FCP-2100ECS.
SWIFT Smart Wireless Integrated Fire Technology
Term Description
Table 1.1 Manual Terminology (Continued)
Type of Device Model Description
Fike IDP Addressable SLC
Devices
See Section 7.1 for a list of compatible devices.
SWIFT Wireless SLC Devices See Section 7.2 for a list of compatible devices
Other Modules FIK-5824 Serial/Parallel
Printer Interface Module
Allows a printer to be attached for the on-site event logging. Maximum of four FIK-5824s per
control panel.
FIK-RPS1000 Power
Supply
Provides additional power, six Flexput circuits, and two Form C relays. Max 8 per system. See
FIK-RPS1000 Installation Manual (PN LS10259-001FK-E) for more information.
FIK-5496 NAC Expander Provides 4 additional Notification Appliance Circuits/Auxiliary power. (Up to 8 per FCP-75
system).
FIK-RA100 and
FIK-RA1000R LCD
Annunciator
4 x20 Remote LCD annunciator. can be used in any combination, up to a total of 8 devices on
one panel.
FIK-RA2000 LCD
Annunciator
4 x 40 Remote LCD annunciator can be used in any combination, up to a total of 8 devices on
one panel.
FIK-5865-3 and
FIK-5865-4 LED
Annunciator
LED annunciator can display up to 30 LEDs (15 red and 15 yellow). FIK-5865-4 has key
switches for silence and reset, and a system trouble LED. FIK-5865-3, FIK-5865-4, and FIK-
5880 can be used in any combination, up to a total of eight devices on one panel.
RA-100TR Trim Ring Trim ring kit for surface mounting the FIK-RA2000/FIK-RA1000R annunciators.
FIK-5880 LED Driver
Module
Driver for up to 40 LEDs. Interfaces with customized annunciator boards. In addition the FIK-
5880 has eight generic switch input points.
FIK-5883 General
Purpose Relay Module
Provides 10 Form C relays. Designed to be driven by the FIK-5880. Up to four, FIK-5883s can
be used with each FIK-5880 module.
FIK-NIC Network Interface Card
FIK-FML Fiber-Optic Multi Mode
FIK-FSL Fiber-Optic Single Mode
Wireless FIK-W-WGI Wireless Gateway
FIK-W-PHOTO Wireless Photoelectric Smoke Detector with 4" base
FIK-W-ACCLIMATE Wireless Multi criteria photoelectric smoke detector with thermal (135°F) with 4" base
FIK-W-HEAT-ROR Wireless heat, ROR/ 135° fixed with 4" base
FIK-W-HEAT Wireless Heat, 135° fixed with 4" base
FIK-W-MONITOR Wireless Addressable Monitor module
FIK-W-RELAY Wireless Addressable Relay module
B210W 6" wireless base
Misc. HFSS Programming Tool For communication and panel programming with a Windows-based computer. Enables remote
viewing of detector status and event history.
7860 Telephone Cord RJ31X cord for connecting phone line to the FCP-75.
7628 UL Listed End-of-line resistor
Table 1.2 FCP-75 Compatible Products