Fike FCP-75 - Table of Contents

FCP-75 Manual — P/N LS10147-003FK-E:A 3/17/2021 5
Table of Contents
Section 1: Introduction ................................................................................................................................................... 10
1.1: Overview of Basic System...............................................................................................................................................................................10
1.1.1: Hardware Features................................................................................................................................................................................10
1.1.2: Network System Hardware Features ....................................................................................................................................................10
1.1.3: Software Features .................................................................................................................................................................................10
1.2: About this Manual............................................................................................................................................................................................10
1.2.1: Terms Used in this Manual...................................................................................................................................................................10
1.3: Compatible Products........................................................................................................................................................................................11
Section 2: Agency Listings, Approvals, and Requirements........................................................................................ 12
2.1: Federal Communications Commission (FCC).................................................................................................................................................12
2.2: Underwriters Laboratories (UL)......................................................................................................................................................................13
2.2.1: Requirements for All Installations........................................................................................................................................................13
Restricted Options: .................................................................................................................................................................................13
2.2.2: Requirements for Central Station Fire Alarm Systems ........................................................................................................................13
2.2.3: Requirements for Local Protected Fire Alarm Systems .......................................................................................................................13
2.2.4: Requirements for Remote Station Protected Fire Alarm Systems........................................................................................................13
2.2.5: Requirements for the Installation of Carbon Monoxide (CO) Detection and Warning Equipment, NFPA 720..................................13
2.2.6: NFPA Requirements.............................................................................................................................................................................14
Section 3: Before You Begin Installing ......................................................................................................................... 15
3.1: Inventory..........................................................................................................................................................................................................15
3.2: Environmental Specifications..........................................................................................................................................................................15
3.3: Software Downloads........................................................................................................................................................................................15
3.4: Electrical Specifications ..................................................................................................................................................................................15
3.5: Wiring Specifications.......................................................................................................................................................................................16
3.6: Board Assembly Diagram................................................................................................................................................................................17
3.7: Calculating Current Draw and Standby Battery ..............................................................................................................................................17
3.7.1: Current Draw Worksheet Requirements...............................................................................................................................................17
3.7.2: Current Draw Worksheet for Fike IDP SLC Devices ..........................................................................................................................18
Maximum Battery Standby Load............................................................................................................................................................20
Section 4: Control Panel Installation............................................................................................................................. 21
4.1: Mounting the Control Panel Cabinet...............................................................................................................................................................21
4.1.1: Preventing Water Damage....................................................................................................................................................................21
4.1.2: Removing the FCP-75 Assembly from the Housing ............................................................................................................................21
4.2: AC Power Connection .....................................................................................................................................................................................21
4.3: Battery Power ..................................................................................................................................................................................................22
4.3.1: Battery Accessory Cabinet ...................................................................................................................................................................23
Installing the RBB Accessory Cabinet and Batteries .............................................................................................................................23
4.4: SBUS Wiring ...................................................................................................................................................................................................24
4.4.1: Calculating Wiring distance for SBUS modules ..................................................................................................................................24
4.4.2: Wiring Configurations..........................................................................................................................................................................26
4.5: FIK-RA100 Remote Annunciator Installation.................................................................................................................................................26
4.5.1: Mounting the FIK-RA100 ....................................................................................................................................................................27
Flush Mounting.......................................................................................................................................................................................27
Surface Mounting ...................................................................................................................................................................................29
4.5.2: FIK-RA100 Connection to the Panel....................................................................................................................................................30
4.6: FIK-RA1000R Remote Annunciator Installation ............................................................................................................................................30
4.6.1: Mounting the FIK-RA1000R................................................................................................................................................................31
Flush Mounting.......................................................................................................................................................................................31
Surface Mounting
...................................................................................................................................................................................32
4.7: FIK-RA2000 Remote Annunciator Installation...............................................................................................................................................33
4.7.1: Mounting the FIK-RA2000 ..................................................................................................................................................................33
Flush Mounting.......................................................................................................................................................................................33
Surface Mounting ...................................................................................................................................................................................35
4.7.2: FIK-RA2000 Connection to the Panel..................................................................................................................................................36
4.8: FIK-5824 Serial/Parallel Printer Interface Module Installation ......................................................................................................................36
4.8.1: Selecting FIK-5824 Options.................................................................................................................................................................37
4.9: FIK-5880 LED Driver Module........................................................................................................................................................................37
4.9.1: FIK-5880 Board Layout .......................................................................................................................................................................38
4.9.2: FACP Connection.................................................................................................................................................................................38