130
5
MAINTENANCE
id.:
DB 460 REV. 00 02/01/2015
5.9 BRAKES
5.9.1 CHECKING AND TOPPING UP THE BRAKE FLUID LEVEL
(fi g. 15)
CAUTION: Before proceeding, always read the safety regulations for the operations to be carried out
as set out in Chapter 3.
5.9.2 CLEANING THE BRAKE FLUID TANK BLEEDERS
(fi g. 15)
Never use petrol, solvents or fl ammable liquids in general for cleaning.
Use only non-fl ammable and non-toxic commercial solvents.
Always wear protective goggles with side screens when working with compressed
air.
Limit the pressure to 2 bar according to the regulations in force.
- Unscrew the bleeder cap A.
- Clean the cap surface with a brush and solvent.
- Clean the bleeder hole with a pointed tool and then dry it with a blast of compressed air.
- Screw the bleeder cap A back on.
DANGER:
CAUTION: It is essential to use only the fl uid indicated in the RECOMMENDED LUBRICANTS AND
FLUIDS TABLE; using unsuitable fl uids will damage the braking system. Regularly check
good functioning of all the braking components.
CAUTION: In the event of malfunctioning, immediately contact the nearest AUTHORISED FIORI
WORKSHOP.
The brake fl uid tank is installed to the side of the revolving driving post.
Always check the brake fl uid level before you start using the vehicle.
15
A
To Next Page
Loading...