Fiori DB 460 - Checking and Adjusting the Alternator Belt Tensioning; Fuel Sediment Bowl

141
5
MAINTENANCE
id.:
DB 460 REV. 00 02/01/2015
5.11.6 FUEL SEDIMENT BOWL (fi g. 27)
5.11.5 CHECKING AND ADJUSTING THE ALTERNATOR BELT TENSIONING
Open the lid only with the engine off.
CAUTION: If you have any doubts about the operating procedures, also refer to the instruction manual
provided separately from this manual. Where necessary, ask an AUTHORISED FIORI
SERVICE CENTRE or WORKSHOP for assistance.
CAUTION: In addition to the operations described below, also refer to the engine manufacturer’s
instruction manual.
- Open the engine compartment lid and check the tension and wear of the alternator belt.
- To work on the belt, refer to the engine manufacturer’s manual attached.
CAUTION: Before proceeding, always read the safety regulations for the operations to be carried out
as set out in Chapter 3.
- Move the vehicle onto fl at ground, engage the parking brake, turn off the engine and remove the ignition
key.
DANGER:
Open the lid only with the engine off.
CAUTION: If you have any doubts about the operating procedures, also refer to the instruction manual
provided separately from this manual. Where necessary, ask an AUTHORISED FIORI
SERVICE CENTRE or WORKSHOP for assistance.
CAUTION: In addition to the operations described below, also refer to the engine manufacturer’s
instruction manual.
CAUTION: Before proceeding, always read the safety regulations for the operations to be carried out
as set out in Chapter 3.
DANGER:
27