Fiori DB 460 - Cleaning Pre-Filter of the Water Pump; Water Pump Emergency Activation

153
5
MAINTENANCE
id.:
DB 460 REV. 00 02/01/2015
5.13.3 WATER PUMP EMERGENCY ACTIVATION (fi g. 38)
To activate a pump that has stopped because of an electrical fault, remove the cap A on the control panel and,
using a screwdriver, act on the distributor button to activate the pump manually.
5.13.4 CLEANING PRE-FILTER OF THE WATER PUMP (fi g. 39)
C
D
39
Before starting the daily work shift, you must clean the pre-fi lter of the water pump.
Remove the closing cap C from the pump, take out the pre-fi lter D and check whether it is dirty inside. To
remove it, use a jet of clean water or compressed air.
Finally, reposition it inside the fi ller neck and refi t the closing cap C.
CAUTION: Check that there is water inside th pump (see chapter 4.3.3 for the related procedure).
38
A