39
3
SAFETY PRECAUTIONS
id.:
DB 460 REV. 00 02/01/2015
If the tyres or rims are incorrectly used, there is a risk of the tyres bursting or getting damaged.
Tyre maintenance, removal, repair and refi tting require special tools and techniques, therefore, always have
these operations carried out by an AUTHORISED SERVICE CENTRE OR AUTHORISED PERSONS.
- Check that the wheel nuts are properly fastened before starting work. If necessary tighten the nuts.
- Always check that the tyre infl ation pressure is as specifi ed by the manufacturer and check that the tyres are
in good condition.
If the tyre pressure is too low, the tyre could overheat and burst. Also if the tyre pressure is too high, there is
a risk of the tyres bursting.
- Check the tyre pressure when the tyres are still cold. Do not release the pressure when it increases in a hot
tyre.
- Keep at a safe distance or stand next to the tyre when infl ating it.
- Keep the working area clear of sharp objects that could damage the tyres.
Defl ate the tyres before removing any foreign bodies that may have lodged in the tread.
- Never use overhauled rims, since improperly carried out welding or heat treatments might weaken them.
- Do not cut or weld the rims when the tyres are fi tted and infl ated.
- Never infl ate the tyres with a gas different from compressed air.
- The tyre pressure values and permitted speed specifi ed in this manual correspond to the values specifi ed by
the manufacturer (see the pressures and loads table).
For more information, contact FIORI or the tyre manufacturer.
Any operation on the electric system or the battery must be carried out by a qualifi ed person.
Before any operation on the electric system, disconnect the battery by removing the key from the battery
master switch. Check that the cables and terminals of the electrical connections show no sign of corrosion,
cracks or burns; if so, immediately contact your local FIORI dealer.
In the event of an electrical fault, do not attempt to start the vehicle by running it downhill.
The battery electrolyte contains sulphuric acid and batteries generate fl ammable hydrogen gas which could
explode. Improper use may cause serious injury or fi re.
- Do not use or charge the battery when the electrolyte level is below the minimum level mark. Check the
electrolyte level at regular intervals and add distilled water to bring it up to maximum level.
- ALWAYS wear protective goggles and rubber gloves when working with batteries.
- Do not smoke or use open fl ames near the battery.
- If the acid comes into contact with your clothes or skin, immediately rinse with abundant water. If the acid
comes into contact with your eyes, immediately rinse with abundant water and seek medical advice.
- The battery must never be tilted more than 45° in any direction, as this may cause the acid to leak out of the
battery.
- Do not connect a fl at battery in series to a charged battery. Risk of explosion!
Do not under any circumstances start the engine by short-circuiting the starter motor terminal or the battery.
3.2.6 TYRE BURSTING
3.2.7 ELECTRICAL RISKS
3.2.8 RISK OF SHORT-CIRCUIT
3.2.9 BATTERY
To Next Page
Loading...