General operation
Page 142 - Chapter 10: General operation 30.10.12
10.2.9 Selecting and saving a unit for the temperature value output
With the Panda iControl2 panel, you can output the temperature values on the display in degrees Celsius [°C] or in
degrees Fahrenheit [°F]. The unit can be switched with the control panel. In the set-up menu, select the menu item
"Degree C/F" and confirm your selection using the Start/Stop button.
Using the cursor buttons, select 0' for outputting all temperatures in degrees Celsius [°C] or 1' for outputting them in
degrees Fahrenheit [°F]. To confirm your selection, actuate the Start/Stop button.
You can enter additional settings in the set-up menu, or you can exit the set-up menu with "Save & Exit". Your
selections will then be saved to the EEPROM of the Panda iControl2 panel.
After restarting the system with the On/Off button, your settings will take effect, and all temperatures will be output
with the selected unit.
Settings options:
0 Output of all temperatures in degrees Celsius [°C]
1 Output of all temperatures in degrees Fahrenheit [°F]
To Next Page
Loading...
