Installation Instructions
30.10.12 Kapitel/Chapter 6: Installation Instructions Seite/Page 53
6. Installation Instructions
Attention! All connections (hoses, wires etc) and installation
instructions are designed and suited for “standard”
installation situations.
In situations where Fischer Panda has no detailed
information concerning certain installation requirements
(such as vehicle specifications, maximum vehicle speed -and
all other conditions concerning special operating situations)
the installation instructions should be used as an example
guide only.
The installation must be undertaken and proved by a suitable qualified/trained person and may in accordance with
the law as required by the country and special situation.
Damages caused by faulty or incorrect installation are not covered by the warranty.
6.1 Personal requirements
The described installation must be done by a technical trained person or a Fischer Panda service point.
6.1.1 Hazard notes for the installation
Notice!:see “Safety first!” on Page 10.
Follow the general safety instruction at the front of this manual.
Warning!: Automatic startDanger for life! - The generator can be equipped with a
automatic start device. This means the generator can be
started by an external signal. To avoid an unexpected
starting of the generator, the starter battery must be
disconnected before start working at the generator.
Warning!: Risk of injuryWorking at a running generator can result in severe
personal injury. Therefore before starting work at the
generator:
Make sure that the generator is stopped and the starter
battery is disconnected to guarantee that the generator
cannot be inadvertently started.
Do not run the generator with removed sound isolation cover
Warning!: Risk of injuryImproper installation can result in severe personal
injuries or material damage.
• Always undertake installation work when the generator is
switched off.
• Ensure there is sufficient installation clearance before start
working.
To Next Page
Loading...
