Fischer Panda 6500 PMS - Installing the New Backend Bearing

Maintenance Instructions
Seite/Page 108 Panda PMS 8.000 NE - 42 NE Manual.R05 - Kapitel/Chapter 6: Maintenance Instructions 22.3.11
Fig. 6.8.1.2-1: Marking the bearing cover.Degrease the spot with a fat solvent as shown, apply markings
with a waterproof pen.
Sample Picture
Fig. 6.8.1.2-2: Demounting the bearing capDemounting the bearing cover
• Unscrew fixing bolts (Tools Allen key SW6).
• Fasten fixing bolts by hand into the holes for disengaging
as far as possible.
• Then alternately fasten these three bolts equaly.
Thus the bearing cover will be pushed out of the generator cap
equally.
• Remove ball bearing with a usual extractor from the shaft.
01. Bearing cover
02. Fixing screw
03. Holes for disengaging
Sample picture
Note: If there is no suitable extractor available, a suitable extractor
can be purchased from Fischer Panda.
Check the O-ring seal which is mounted in the bearing cover
and replaced if damaged.
6.8.1.3 Installing the new backend bearing
02
01
02
02
03
03
03