Fischer Panda 6500 PMS - Checking the Oil Level of the Generator End Bearing at Fischer Panda Generators; Oil Level Check

Maintenance Instructions
Seite/Page 112 Panda PMS 8.000 NE - 42 NE Manual.R05 - Kapitel/Chapter 6: Maintenance Instructions 22.3.11
6.9 Checking the oil level of the generator end bearing at Fischer Panda
generators
The oil level check is a visual check. Older generators are equipped with an sight glass, newer ones with an sight
hose.
Fig. 6.9-1: Oil check
If your generator does not feature these control modules or if these are not accessable, please refer to your Fischer
Panda distribution partner or to Fischer Panda directly. The correct oil level is at the middle of the sight glass/ sight
hose.
Oil level check is only to be executed when the generator is switched off!
6.9.1 Oil level check
Fig. 6.9-1: Oil level check
01
02
03
Older version Newer version
01. Screw plug
02. Sight glass
03. Sight hose
Oil level check
Oil level is fine:
Generator can be started.
Next check: after 25 hours
Oil level is NOT correct:
Correct the oil level. Let generator
run for 3 minutes
Oil level is fine:
Generator can be started.
Next check: after 5 hours
Oil level still NOT correct:
Do NOT restart generator!
Oil level is fine:
Generator can be started
Oil level still NOT correct:
Refill oil
Let generator run for 3 minutes