Maintenance Instructions
Seite/Page 116 Panda PMS 8.000 NE - 42 NE Manual.R05 - Kapitel/Chapter 6: Maintenance Instructions 22.3.11
Fig. 6.10.2-5: Loosen fastening screws
Unscrew the fastening screws (Tool: Allen wrench SW6).
Fig. 6.10.2-6: Insert lifting screws
As shown, screw in 3 lifting screws M8x50 as far as possible by
hand.
Fig. 6.10.2-7: Pull off the bearing seat
Then screw in those 3 screws with a screw wrench SW13
equally and in turns.
By doing this, the bearing housing including the ball bearing and the shaft
sealing ring are pushed out of the generator cap.
To Next Page