Maintenance Instructions
22.3.11 Panda PMS 8.000 NE - 42 NE Manual.R05 - Kapitel/Chapter 6: Maintenance Instructions Seite/Page 119
Fig. 6.10.2-13: Remove O-ring
Remove O-ring from the oil cap.
Clean the bearing seat and the oil cap.
Slightly lubricate the new O-rings and mount them.
Fig. 6.10.2-14: Mounting the shaft sealing ring
Mounting the NEW shaft sealing ring:
Lubricate/grease the shaft sealing rings’ lip seal.
Fig. 6.10.2-15:
Clean the mandrel, slightly grease/lubricate the connecting
surface and the chamber-bevel.
To Next Page