Maintenance Instructions
22.3.11 Panda PMS 8.000 NE - 42 NE Manual.R05 - Kapitel/Chapter 6: Maintenance Instructions Seite/Page 121
Fig. 6.10.2-19: Cleaning the shaft
Clean the shaft
Fig. 6.10.2-20: Checking the wheel tread
Check the wheel tread for damages
The wheel tread has to be
- clean
- free of partial damages (drafts, indentations, notches, scratches).
Fig. 6.10.2-21: Mounting the bearing housing
Mounting the bearing housing inside the generator cap:
Put the bearing housing loosely into the generator cap; securing it against
dropping out with one hand.
Please make sure the housing is mounted in the same position as it was
before - the marking that have been made before dismounting have to fit to
each other again!
To Next Page