FLAMIC S.R.L. 5 Via dell’Artigianato, 36035 Marano Vicentino (Vicenza) - Italy
54
Dough sheeter SF450 - SF500 - SF600 Operation and maintenance manual (translation of original instructions) – Ed. 10/2016
Rev.02 10/2017
All rights reserved. Reproduction in whole or in part of this manual is prohibited.
5 SAFETY
5.1 FOREWORD
The considerations referred to in this chapter are based on the assumption that:
•
the customer/user and every operator assigned to the machine is/are fully aware of the conditions of use
and the intended use of the machine that are envisaged and specified in this manual.
•
the operators have been adequately informed and trained regarding risks in the workplace in compliance
with, among other things, the law in force in the European Community
•
access to the workplace is prohibited to unauthorized persons, untrained persons and children
5.2 HAZARDS, SAFETY DEVICES AND RESIDUAL RISKS
5.2.1 HAZARDS ASSOCIATED WITH THE MACHINE
With reference to Figure 45, the following hazards and relative risks are associated with the machine.
hazards of a mechanical nature:
A. Trapping, dragging, crushing: between the thicknessing rollers as well as between the thicknessing rollers
and adjacent parts (uprights, scrapers), between the conveyor belt drive cylinders closest to the rolling zone
and scrapers
B. Trapping and dragging, entrapment, cutting, crushing: between the drive components on both sides of
the machine base
C. Trapping and dragging, crushing: in the zones where the conveyors and the drive cylinders/guide meet
D. Crushing, cutting: between the rollers of the cutting unit and the bench.
Figure 45 - Hazards of a mechanical nature
A A
B
C C
D
A - C A - C
To Next Page
Loading...
