ISO ANSI Warning
--- Warning - hand injuries
ATEX certification
2.5 Special types of danger and personal protective equipment
Requirements
Fulfil the following requirements before commencing work on the gear unit:
● Ensure that the oil pressure lines are depressurised.
● Only perform work on the gear unit when it is not in operation.
● Disconnect electrical systems from the power supply.
DANGER
Electric shock
Live parts can cause electric shock.
Ensure that the entire plant is de-energised before starting electrical installation work.
Protective equipment
Wear the following personal protective equipment when handling the gear unit:
● Safety shoes
● Overalls
● Helmet
● Safety gloves
● Safety goggles
WARNING
Risk of eye injury
Small foreign particles such as sand or dust can enter the cover plates of the rotating parts
and be hurled back by them.
Wear safety goggles.
Safety instructions
2.5 Special types of danger and personal protective equipment
Gear unit 5118en
16 Operating Instructions 10/2017
To Next Page
Loading...
