FLENDER H2SH 24 - Bearing Arrangement of the Shafts; Pressure Lubrication; Splash Lubrication

3.4.1 Splash lubrication
Unless otherwise agreed by contract, the gearing and rolling-contact bearings are supplied
with an adequate quantity of oil by splash lubrication.
3.4.2 Pressure lubrication
At high input speeds or high gear circumferential velocities, depending on the particular
contract, splash lubrication can be supplemented or replaced by pressure lubrication.
With pressure lubrication, the rolling-contact bearings and gears located above the oil level
are adequately supplied with oil through pipes.
Designs
The following designs are possible:
● Mounted oil supply system
● Separate oil supply system???
Further information
Additional information and a detailed illustrated description of the gear unit and the oil supply
system can be found in the dimension drawing in the complete gear unit documentation.
Additional information about the oil supply system can be found in the separate data sheet, in
the list of equipment and in the oil supply system operating instructions provided in the
complete gear unit documentation.
Mounted oil supply system with motor pump
The oil supply system is mounted on the gear unit and comprises the following components:
● Motor pump
● Double change-over filter
● Pressure monitor
● Piping
Further information
Additional information and a detailed illustrated description of the gear unit and the oil supply
system can be found in the dimension drawing in the complete gear unit documentation.
3.5 Bearing arrangement of the shafts
All shafts are mounted on rolling-contact bearings.
Description
3.5 Bearing arrangement of the shafts
Gear unit 5118en
Operating Instructions 10/2017 25