FLENDER H2SH 24 - Gear Unit 5118 En Operating Instructions 10;2017

Figure 4-9 Preservation of gear units with Tacolab seals.............................................................................54
Figure 5-1 Gap dimension at grease labyrinth..............................................................................................59
Figure 5-2 Alignment surface........................................................................................................................60
Figure 5-3 Alignment surfaces and alignment thread at the gear unit..........................................................61
Figure 5-4 Foundation block.........................................................................................................................63
Figure 5-5 Inserted anchor bolt.....................................................................................................................64
Figure 5-6 Tightened anchor bolt..................................................................................................................65
Figure 5-7 Possible displacements...............................................................................................................67
Figure 5-8 Alignment process based on the example of a flexible coupling.................................................68
Figure B-1 Rating plate...............................................................................................................................105
Table of contents
Gear unit 5118en
Operating Instructions 10/2017 9