● Vibration measurement using acceleration sensors
Depending on the specific order, you can measure vibration levels at the following locations:
– Outside in the area of the input and the two output shafts
– In the gear unit in the area of the two output shafts
● Torque measurement at the input and output shafts
● Oil level monitoring using separate valves
● Bearing monitoring using shock pulse measurement
Further information
You will find further information, a detailed illustration of the gear unit and the position of the
mounted components in the dimension drawing in the complete documentation for the gear
unit.
You will find further information on the gear unit monitoring "Condition Monitoring", such as
control information and technical data, in the operating instructions for the gear unit monitoring
"Condition Monitoring" and in the list of equipment, which are part of the complete
documentation of the gear unit.
Description
3.16 Gear unit monitoring "Condition Monitoring"
Gear unit 5118en
44 Operating Instructions 10/2017
To Next Page
Loading...
