16 Settings FLUXUS ADM 8027, F801, ADM 8127B
UMFLUXUS_F8V4-6-1EN, 2018-10-10 115
16.4 Setting the Contrast
It is possible to reset the display to medium contrast. Enter HotCode 555000 (see section 10.4).
16.5 Instrument Information
Select Special Funct.\SYSTEM settings\ Miscellaneous to set the contrast of
the display of the transmitter. Press ENTER.
The contrast of the display is adjusted with the following keys:
increases the contrast
reduces the contrast
Note!
After an initialization of the transmitter, the display is reset to medium contrast.
Select Special Funct.\Instrum. Inform. to display information about the transmit-
ter. Press ENTER.
The type and the serial number of the transmitter is displayed in the upper line.
The available data logger memory will be displayed in the lower line (here: 18 327 addition-
al measured values can be stored). For further information about the data logger see sec-
tion 14.1.6.
Press ENTER.
The type and the serial number of the transmitter is displayed in the upper line.
The firmware version of the transmitter with the date is displayed in the lower line.
Press ENTER.
SYSTEM settings↕
Miscellaneous
SETUP DISPLAY
← CONTRAST →
Special Funct. ↕
Instrum. Inform.
X80X -XXXXXXXX
Free: 18327
X80X -XXXXXXXX
V x.xx dd.mm.yy
To Next Page
Loading...
