Flexim FLUXUS F801 User Manual

FLUXUS ADM 8027, F801, ADM 8127B 10 Start-Up of the Transmitter
72 UMFLUXUS_F8V4-6-1EN, 2018-10-10
10 Start-Up of the Transmitter
10.1 Switching on
10.2 Initialization
During an initialization (INIT) of the transmitter, the settings in the program branches Parameter and Output Options
and some of the settings in the program branch Special Funct. are reset to the default settings of the manufacturer.
For INIT-resistant settings, see annex A.
Proceed as follows to execute an initialization:
• While switching on the transmitter: keep keys BRK and CLR pressed.
• During the operation of the transmitter: press keys BRK, CLR and ENTER at the same time. A RESET is executed. Re-
lease only key ENTER. Keep keys BRK and CLR pressed.
After the initialization, the remaining settings of the transmitter can be reset to the default settings and/or the stored mea-
sured values can be deleted.
10.3 Display
10.3.1 Main Menu
The selected program branch is displayed in capital letters between arrows. The complete designation of the selected pro-
gram branch is displayed in the lower line.
Select a program branch with key and . Press ENTER.
As soon as the transmitter is connected to the power supply, the serial number of the trans-
mitter is displayed for a short time.
It is not possible to enter any data while the serial number is displayed.
Afterwards, the main menu is displayed in the default language. The language of the dis-
play can be set (see section 10.5).
After the initialization has been executed, the message INITIALISATION DONE is dis-
played.
Select yes to reset the remaining settings to the default settings or no to keep them at the
current settings.
Press ENTER.
If yes is selected, the message FACTORY DEFAULT DONE will be displayed.
Select yes to delete the stored measured values or no to keep them stored.
Press ENTER.
This display will only be indicated if measured values are stored in the data logger.
The main menu contains the following program branches:
• par (Parameter)
• mea (Measuring)
• opt (Output Options)
• sf (Special Functions)
Note! By pressing key BRK, the measurement is stopped and the main menu is selected.
Note! In this user manual, all program entries and keys are indicated with typewriter characters (Parame-
ter). The menu items are separated from the main menu by a backslash "\".
FLEXIM FLUXUS
X80X -XXXXXXXX
>PAR<mea opt sf
Parameter
INITIALISATION
----DONE----
FACTORY DEFAULT?
no >YES<
Delete Meas.Val.
no >YES<
>PAR< mea opt sf
Parameter

Flexim FLUXUS F801 Specifications

General

Brand	Flexim
Model	FLUXUS F801
Category	Measuring Instruments
Language	English