A Menu structure FLUXUS F808, F809
UMFLUXUS_F808_8091V1-2-1EN, 2019-08-23 173
SYSTEM settings\Storing
selection of the displays for the storing of measured values in the data logger
setting of the overflow behavior of the data logger x
selection of the storage mode
• sample: storing and online transmission of the displayed measured value
• average: storing and online transmission of the average of all measured val-
ues of a storage interval
x
setting of the storing behavior of the totalizers
• one: the value of the totalizer that is currently displayed will be stored
• both: one value for each flow direction will be stored
x
activation of the storing of the signal amplitude
The value will only be stored if the data logger is activated.
x
activation of the storing of the sound speed of the fluid
The value will only be stored if the data logger is activated.
x
activation of the storing of diagnostic values x
SYSTEM settings\serial transmis.
selection of the displays for the formatting of the serial transmission of mea-
sured values
activation of the serial transmission of data with/without blanks x
selection of the decimal marker for floating point numbers x
selection of the character for column separation x
selection of the serial interface
default: RS232
This display will only be indicated if the transmitter has an RS485 interface.
x
SYSTEM settings\Network
change of the settings of the transmission parameters of the RS485 interface
input of the address of the measuring instrument x
confirmation or change of the transmission parameters x
INIT-
resistant
SYSTEM settings↕
Storing
Ringbuffer
off >ON<
Storage mode
sample >AVERAGE<
Quantity Storage
one >BOTH<
Store Amplitude
off >ON<
Store c-Medium
off >ON<
Store diagnostic
off >ON<
SYSTEM settings↕
serial transmis.
SER:kill spaces
off >ON<
SER:decimalpoint
’.’ >’,’<
SER:col-separat.
’;’ >’TAB’<
Send Offline via
RS232 >RS485<
SYSTEM settings↕
Network
Device address:
0 ADR
RS485 protocol
default >SETUP<
To Next Page
Loading...
Need help?
General
