Flexim FLUXUS WD - Page 161

Annex
FLUXUS WD A Menu structure
161
UMFLUXUS_WDV1-3EN, 2018-07-16
Remote functions
(see chapter 17)
Trigger
Special functions Options
Inputs Channel x
Condition
Event trigger
Temperature Current Voltage Binary
Enable Enable Enable Enable Select RX
Pt100/Pt1000 Source item Source item Negate input Rx Enable
 Yes
 No
Source item
Condition
Trigger value
Function
Yes
 MAX (x>limit)
 MIN (x<limit)
 Within range
 Out of range
 ERR (x=fail)
 Out of range
 ERR (x=fail)
 MAX (x>limit)
 MIN (x<limit)MIN
(x<limit)
 ERR (x=fail)
Type
Range center Trigger value
Range width Hysteresis Non-hold Hold for a while Hold
Hold interval
Glitch interval
[1]
Input info
 Within range
 Out of range
 MAX
 MIN
 ERR
Test signal
Range center Trigger value
Range width Hysteresis
Glitch interval
Action
Failure delay
Options
Channel x
Remote functions
 Reset meas. val. [3]
 Reset totalizers
 Stop totalizers
 Activate FastF [2]
 Not for calc. [2] Legend
[1] depending on the selection of the function
[2] not available with calculation channels and only if FastFood mode is
enabled in Special functions > Measurement > Measurement modes
[3] only controllable via inputs
[4] list of parameterized inputs and event triggers
Input/
Event trigger [4]
1
2