Flexim FLUXUS WD - Wall Installation

6 Installation
6.1 Transmitter FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
26
6.1.2 Opening and closing the housing
Opening
• Loosen the screws of the transmitter housing, see Fig. 6.2 and Fig. 6.3.
• Open the housing cover of the transmitter.
Closing
• Close the housing cover.
• Tighten the screws of the transmitter housing, see Fig. 6.2 and Fig. 6.3.
(transmitter with stainless steel housing: a max. torque of 1 Nm)
6.1.3 Installation of the transmitter
6.1.3.1 Wall installation
Transmitter with stainless steel housing
• Fix the transmitter with 4 screws to the wall, see Fig. 6.4.
Important!
Do not use objects which may damage the housing gasket to open the cover housing.
Fig. 6.2: Transmitter with stainless steel housing
1–screws
1
Fig. 6.3: Transmitter with aluminum housing
1–screws
1
Fig. 6.4: Transmitter with stainless steel housing (dimensions in mm)
1 – fixing hole for wall mounting Ø 9.5
1
240
280
min. 130