Flexim FLUXUS WD - Page 37

6 Installation
FLUXUS WD 6.2 Transducers
37
UMFLUXUS_WDV1-3EN, 2018-07-16
Step 1: Dismounting of the transducer mounting fixture Variofix L
• Disassemble the transducer mounting fixture Variofix L, see Fig. 6.13.
Step 2: Fixing the clasps to the tension straps
• Select the installation instructions according to the supplied clasp:
Band clamp clasp
The clasp is fixed to the tension strap, see Fig. 6.14.
Quick release clasp
The clasp is fixed to the tension strap, see Fig. 6.15.
• Cut the tension strap to length (pipe circumference + at least 120 mm).
Ratchet clasp
• Cut the tension strap to length (pipe circumference + at least 120 mm).
Fig. 6.13: Dismounting of the transducer mounting fixture Variofix L
1–cover
2–screw
3 – nut
4–rail
5 – tension strap clamp
Fig. 6.14: Band clamp clasp with tension strap Fig. 6.15: Quick release clasp with tension strap
Caution!
The edge of the tension strap is very sharp.
Risk of injury!
 Debur sharp edges.
 Wear the required personal protective equipment. Observe the applicable rules.
1
2
3
4
5
5