Flexim FLUXUS WD - Page 40

6 Installation
6.2 Transducers FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
40
Step 4: Fixing the rail to the pipe
• Place the tension strap clamp (2) in the rail, see Fig. 6.23. Observe the orientation of the tension strap clamp.
• Tighten the nut of the tension strap clamp (2) slightly.
• Screw the rail to tension strap clamp (1), see Fig. 6.24.
• Tighten the nut of tension strap clamp (1), but not too firmly in order not to damage the tension strap.
• Select the installation instructions according to the supplied clasp:
Fig. 6.21: Tension strap with metal spring and clamp
1–metal spring
2 – tension strap clamp
Fig. 6.22: Ratchet clasp with tension strap
1 – sense of rotation
2 – edge
3–lever
4 – clasp screw with slot
Fig. 6.23: Rail with tension strap clamp
1 – nut
2 – tension strap clamp
Fig. 6.24: Rail, mounted on one side of the pipe
1 – tension strap clamp
2 – tension strap clamp
3 – nut
12
1
2
4
3
4
1
2
2
1
3
1