Flexim FLUXUS WD - Page 44

6 Installation
6.2 Transducers FLUXUS WD
2018-07-16, UMFLUXUS_WDV1-3EN
44
• Tighten the cover screws, see Fig. 6.33.
Fig. 6.32: Adjustment of the transducer distance
1–cover
2 – strain relief clamp
3 – equipotential bonding terminal
a – transducer distance
Notice!
Make sure that the coupling foil remains on the contact surface of the transducers. For information concerning the
coupling foil, see the safety data sheet In case a safety data sheet is required, contact FLEXIM.
Fig. 6.33: Variofix L with transducers on the pipe
1 – equipotential bonding terminal
2 – cover screws
12
a
3
2
1