7 Connection
FLUXUS WD 7.4 Service interfaces
67
UMFLUXUS_WDV1-3EN, 2018-07-16
• Push the cable through the cap nut, compression part and basic part of the cable gland.
• Insert the cable into the housing of the transmitter.
• Prepare the cable. For the preparation of the cable, see the supplied manufacturer's documents.
• Mount the connector. For the mounting of the connector, see the delivered manufacturer's documents.
• Insert the connector into the Ethernet port, see Fig. 7.16.
• Fix the foldable ferrite core to the cable.
• Position the cable in the housing as shown in Fig. 7.16.
• Screw the sealing ring side of the basic part into the transmitter housing.
• Fix the cable gland by screwing the cap nut onto the basic part, see Fig. 7.16.
Fig. 7.17: Cable gland
1 – cap nut
2 – compression part
3 – basic part
To Next Page
Loading...
