Flexitron Webdyn SunPM - 5.3.9 “setRelay”: Changing the state of the relay; 5.3.10 “discoverDevices”: Discovery of equipment

contact@webdyn.com | webdyn.com
V2.05 subject to changes | Webdyn © by Flexitron Group
185
And answer:
[
{“callerId”:”672”, “result”:”OK”},
{“callerId”:”673”, “error”:”Invalid interface: ethernet”}
]
Example SMS :
log=serial1:5
5.3.9 “setRelay”: Changing the state of the relay
Modies the state of the relay: open, close or 1s pulse.
Available via command le (FTP, SFTP or WebDAV), MQTT/MQTTS message and SMS.
setrelay=<action>
Settings:
• action: Action to execute: open, close or pulse.
Return:
• If successful for a JSON command: “OK”.
• If successful for an SMS command: no return.
• If an error is encountered: an explanatory message.
Example SMS :
setrelay=pulse
5.3.10 “discoverDevices”: Discovery of equipment
Triggers a device discovery.
Available via command le (FTP, SFTP or WebDAV), MQTT/MQTTS message and SMS.
discoverdevices=<protocol>:<maxDevices>:<interface>:<timeout>:<port>