contact@webdyn.com | webdyn.com
V2.05 subject to changes | Webdyn © by Flexitron Group
Ethernet port default parameters:
PARAMETERS LAN1 LAN2
IP address 192.168.1.12 192.168.2.12
Subnet mask 255.255.255.0 255.255.255.0
The Ethernet ports each support and include:
• A 10Base / 100Base-Tx IEEE 802.3 link.
• 2 indicators:
• “Link” (green): Used to check that the physical link with another network device is
available.
• “Status” (orange): Used to view network trafc. It ashes depending on the trafc.
• Automatic signal detection and crossing.
• A speed (10/100 Mbps) and mode (half/full duplex) auto-negotiation.
If you want to connect several IP devices to the same network, the devices must have different IP
addresses but belong to the same subnet. Never use the same IP address twice.
2.4.6 RS485/RS422 Serial Interface
The WebdynSunPM concentrator has 3 RS485/RS422 serial ports marked “Serial” on the bottom of the
product which are only used for modbus in RTU mode. This interface is Half Duplex (2 wires) and Full
Duplex (4 wires) compatible.
To Next Page
Loading...