Flexitron Webdyn SunPM - Appendices; 9.1 Appendix A: _config.ini file

contact@webdyn.com | webdyn.com
V2.05 subject to changes | Webdyn © by Flexitron Group
196
9. Appendices
9.1 Appendix A: “_cong.ini” le
The authorised conguration parameters in the “<uid>_cong.ini” le are the following:
PARAMETER DESCRIPTION DEFAULT
VALUE
BIN_Checksum Indicates the rmware name to use to update
the gateway software. This parameter cannot
be empty if BIN_FileName contains a value. The
rmware thus named must be in the congured
binary directory.
See the section on update conguration for how
to use updates.
BIN_FileName Indicates the checksum for the rmware
indicated in the BIN_FileName eld. This
parameter cannot be empty if BIN_Checksum
contains a value.
See the section on update conguration for how
to use updates.
Concentrator_Identier Gateway identier (uid). If this eld is left empty,
the default identier is used.
WPMABCDEF
(where
ABCDEF
are the last
characters
of the serial
number).
FTP_DirAlarm FTP 1 server directory in which the alarms
from the concentrator are stored. Note that the
directory MUST exist. The concentrator will not
create it when uploading les.
/ALARM
FTP_DirBin FTP 1 server directory in which the concentrator
will get the update les when requested. See the
section on update conguration for how to use
updates.
/BIN
FTP_DirCert FTP 1 server directory in which the concentrator
will get the certicates to use for MQTT
connections. See the MQTT conguration section
for more details.
/CERT